SOVA slider designs are characterized by color saturation and incredibly cool designs. The base consists of an ultra-thin polymer film on a paper base. The film is easily separated from the substrate after soaking in water, it is very plastic and due to this perfectly repeats the shape of the nail, you can adjust the image without any effort. Provided correct application and compliance with the instructions, the sock is guaranteed until correction.

Instructions for working with slider design

1. Prepare the nail plate;
2. Select the desired design by 0.5-1 mm. step back from the drawing and cut out the shape;
3. Apply base coat and cure.
4. Cover with colored gel polish in 1-2 layers and dry in a lamp;
5. Apply a thin layer of top coat and dry;
6. Put the cut pattern on a napkin (pre-soaked in warm hot (not cold) water for 15-20 seconds).
7. Bring to the nail, and using the shear method, separate the film from the paper base by 1/3, pressing the film at the base of the cuticle, leaving a margin of 0.5-1 mm at the cuticle line, remove the backing.
8. Carefully straighten the film and avoid the formation of folds, push out the remaining air and water with the help of a soft napkin.
9. Dry the nails with a slider design in the lamp;
10. With the help of a saw, carefully remove the excess film from the free edge of the nail in an up-down motion.
11. Dip a lint-free cloth in degreaser and treat the edge of the nail;
12. Apply the top coat (seal the ends and edges of the film near the cuticle and side rollers in 2 layers, polymerizing all layers in the lamp).
13. If you have a top with a sticky layer, remove the sticky layer.