HEYLOVE "Water Drops" Top, 2 x 15 ml

Water Drops Top

A two-component kit for creating three-dimensional “drops” on the surface of the coating.

Set contents:
Step 1 — a glossy top coat without a tacky layer. Can be used as a regular finish coat.
Step 2 — a liquid gel without a tacky layer that naturally rolls into droplets and creates a dew effect.

Directions for Use

1) Base Preparation
Apply Step 1 to the finished design or base color and cure under the lamp for 60 seconds.
After curing, do not touch the surface with your hands or wipe it.

2) Creating “droplets”
Apply a small amount of Step 2 and wait until the gel forms the desired droplet effect.
If necessary, repeat the application to enhance or refine the result.
Cure under the lamp for 60 seconds.

APPENDIX TO THE INSTRUCTIONS (Curing, Application, and Content Removal Conditions)

• Apply Step 1 in a thin layer (do not apply too thickly).

• Cure Step 1 and Step 2 only in a 48W lamp.

• Cure continuously. Curing time: no more than 60 seconds.

• For white coatings, 30 seconds is sufficient to prevent yellowing.

• Lower-wattage lamps and LED flashlights may cause the coating to yellow.

When shooting content:

• Table lamps with cool light (5600K and higher ) can trigger the curing process.

• While filming, do not position the lamp too close to the bottle and brush— the brush may become stiff.

• We recommend filming this stage quickly, without prolonged exposure to light.

Volume: 2 x 15 mL

Manufacturer: "HEYLOVE"TM

Country: Ukraine

Ingredients: Acrylates Copolymer, HEMA, Cellulose Acetate Butyrate, Pentaerythritol, Mercaptopropionic Acid, Dimethicone, BHT.

Warning! To prevent unwanted polymerization of the material during use, testing, or content creation, keep the open bottle or brush as far away from daylight as possible (especially direct sunlight). Please also note that even on cloudy days, clouds allow a significant amount of ultraviolet radiation to pass through, which is sufficient to cause the material to polymerize.