HEYLOVE Smart Builder Gel Wet, 15 ml

Wet – a delicate shade of blue.

A liquid building gel in a bottle. It allows for quick nail extensions without filing, strengthening natural nails, and smoothing out and correcting imperfections in the nail plate.

The product does not heat up during curing and does not cause discomfort.

Collection: Tactile

Consistency: liquid

Hardness/Elasticity: Medium elasticity

Directions for use:

1. Buff the nail plate with a 180-grit file or a 100-grit buff.
2. Wipe with a degreaser to remove dust, especially under the cuticle and in the lateral grooves.
3. Apply the phBond dehydrator and wait 30 seconds for it to evaporate the moisture.
4. Using rubbing motions, apply a primer coat of rubber base and add a small amount more of the base to create a smooth surface. Cure for 30 seconds.
5. Remove the dispersion (sticky) layer from the base after curing, especially under the cuticle.
6. Apply Smart Gel in a structural layer. Cure for 30 seconds, then place both hands under the lamp again for 1 minute.
7. Remove the sticky layer from the Smart Gel.
8. Buff the surface as desired and be sure to file the edges to create the desired gel thickness.
9. Apply a top coat as the final layer. Cure for 1–2 minutes.
10. Using a carbide “corn” bit, file away the natural nail from the free edge area starting from the bottom.
11. Carefully buff the end with a buffing pad to avoid damaging the surface of the coating.
12. Wipe away any dust with a damp cloth and apply cuticle and hand care products. Done!

Volume: 15 ml

Manufacturer: TM "HEYLOVE"

Country: Ukraine

Ingredients (INCI): Acrylates Copolymer, HEMA, Ethyl Trimethylbenzoyl Phenylphosphinate, Hydroxycyclohexyl Phenyl Ketone.
May Contain: Cl 45380, CI 15850, Cl 77491, CI 15985, CI 77492, CI 77007, Cl 77510, Cl 77742, Cl 77289, Cl 77499, Cl
77891, CI 77000.

Warning! To prevent unwanted polymerization of the material during work, testing, or content creation, keep the open bottle or brush as far away from daylight as possible (especially direct sunlight). Please also note that even on cloudy days, clouds allow a significant amount of ultraviolet radiation to pass through, which is sufficient to cause the material to begin curing. When painting tips, we recommend keeping the working side of the UV lamp turned away from the technician. If the lamp is left on with the light facing the technician, unwanted polymerization of the material may occur on the brushes and on the necks of open bottles.